VICTRON VE NET CONTROL PANEL

The VE.Net Panel provides a user interface to all connected VE.Net devices. This could be one or more VE.Net Battery Controllers, VE.Net Generator Modules, regular Victron Energy equipment such as inverters and the Multi Inverter/Charger combination, or other third party equipment.

Plug and play - no setup needed!
To install the panel you have to connect it to the VE.Netnetwork with a standard UTP cable. After power up, the panel searches for all the available VE.Net devices on the network and automatically loads them.

Alarms

The VE.Net Panel has a buzzer and a set of contacts,which both can be setup to activate when there is an alarm on the VE.Net.

IVICTRON VE NET BATTERY CONTROLLER

No more guessing

Identifying exactly how much energy is left in a battery is not easy. A voltmeter is useful but will only indicate that the battery is flat when it is too late. In order to keep an accurate record of what is stored in a battery it is necessary to keep account of all the factors that affect it and this is a complex matter. Once a reliable reading of the state of charge of the battery is available however, life starts to get an awful lot less complicated. No more nasty surprises with batteries going flat unexpectedlyand it becomes possible to manage batteries on fact rather than guess work. It is amazing how much power you can have with a little extra knowledge! Accurate and reliable The data used by the VE.Net Battery Controller is monitored with an accuracy better than 0,5% and, employing Peukert formula, account is taken of the reduction of effective capacity of the battery when the discharge current increases. An optional temperature sensor helps to further improve accuracy where wide temperature variation is expected.

VICTRON VE NET INTERFACE

Required to connect VE NET to MultiPlus see diagram above